NOE Forums

Inventory Runs => What you would like to see ran => Topic started by: rsterne on November 12, 2017, 06:13:31 PM

Title: BBT Airgun HPs
Post by: rsterne on November 12, 2017, 06:13:31 PM
I have just gone through the Inventory in the NOE Store, and notice that ALL of the commonly used .22 cal and .25 cal Bob's Boattail Hollowpoint Airgun Moulds have been sold out.... This includes the 0.217/0.219"" and 0.220/0.222" 30 gr., the 0.250/0.252" in 41 gr. and 51 gr., and the 0.253/0.255" in 41 gr. and 51 gr.... If there is anyone interested in seeing these run again, please post in this thread....

Al, is it possible to drill existing moulds in your Inventory for the Lyman HP pin, or does that have to be done at the time of manufacture?.... There are a few FN moulds left, but no HPs....

Bob
Title: Re: BBT Airgun HPs
Post by: SwedeNelson on November 13, 2017, 03:42:52 PM
Bob

Not set up to run moulds back through the system at this time - sorry
Lets see what the response is to this thread.
Can work them in easy enough.

Working on a run of the .217/.219 now.

Bullet maker, maker
Al Nelson
Title: Re: BBT Airgun HPs
Post by: rsterne on November 13, 2017, 04:17:00 PM
I would go heavier on the HP moulds, they seem to be more popular.... JMO....

Bob