Slug mould

Home › Forums › NOE Forums › NOE Archive › Historical Archive › Group Buys › Group Buy Discussions › Slug mould

  • This topic is empty.
  • Creator
    Topic
  • 2014-06-26 at 10:49 #487407
    adamsutherland
    Moderator
      Up
      0
      Down
      ::

      I would like to have a decent slug mould for making soft lead slugs for bore slugging and making impact casts.

      A five cavity mould with say .220″, .240″, .260″, .300″, .320″ or slightly undersized cylinders.

      Could do a similar one for pistol calibres as well.

      Any one else interested?

    • Creator
      Topic
    Viewing 1 replies (of 1 total)
    • Author
      Replies
    • 2014-07-01 at 15:15 #491981
      adamsutherland
      Moderator
        Up
        0
        Down
        ::

        Looks like I’m the only one up for one of these, been trying to get one made for years, but I seem to be the only one interested in this.

        It nice to get a good fitting smooth lead cylinder for tacking an impact cast, I get my best ones with lead wire of bore diameter but lead wire diameters are limited around me.

        If I had access to someone with the suitable skills and tools then I could just get blank blocks and have them drilled but in the once heartland of the industrial revolution and the centre of Britain’s heavy engineering industry finding those skills now is very hard.

      • Author
        Replies
      Viewing 1 replies (of 1 total)
      • You must be logged in to reply to this topic.