sprue plate lube

Home › Forums › NOE Forums › NOE Archive › Historical Archive › Using NOE Moulds › Casting and Reloading › sprue plate lube

  • This topic is empty.
  • Creator
    Topic
  • 2014-12-08 at 23:17 #487752
    roberthutton
    Participant
      Up
      0
      Down
      ::

      I was going to print out the sprue plate lube directions but i cant find them.Dose anyone know where they are?Thanks Bob

    • Creator
      Topic
    Viewing 3 replies - 1 through 3 (of 3 total)
    • Author
      Replies
    • 2014-12-09 at 06:44 #494717
      lar45
        Up
        0
        Down
        ::

        What I do is cast until your mold is hot.
        Then pour one more, cut the sprue, but leave the boolits in the mold.
        Put some lube onto a soft cloth and rub it all over the top of the mold and both sides of the sprue plate.

        2014-12-16 at 21:26 #494718
        dannyhunley
        Participant
          Up
          0
          Down
          ::

          Good to see you on the forum, LAR.  Love your lube! 

          2014-12-16 at 23:11 #494719
          Intel6
          Participant
            Up
            0
            Down
            ::

            Yes,  Welcome!

            I just noticed that NOE is selling your great lubes, I have been using Carnuba Red for years and really like it.

            Neal in AZ

          • Author
            Replies
          Viewing 3 replies - 1 through 3 (of 3 total)
          • You must be logged in to reply to this topic.