What thread is the grub screw?

Home › Forums › NOE Forums › NOE Archive › Historical Archive › General › Forum Questions / Problems › What thread is the grub screw?

  • This topic is empty.
  • Creator
    Topic
  • #487784
    lwatson
    Participant
      Up
      0
      Down
      ::

      I have lost the sprue-lever tightener hex-grub screws (the one on the sides) now on 3 of my NOE molds, my eyes and even a magnet just never find the little buggers when they fly off, clearly into other dimensions.

      I think I could easily order spares from an auction site – what’s the thread/pitch on the grub screws?

    Viewing 8 replies - 1 through 8 (of 8 total)
    • Author
      Replies
    • #495030
      teemu
      Participant
        Up
        0
        Down
        ::

        I lost few also :(  Could these screws become spare parts like those RG pins…?. I wonder how those get missed…I use hand to open sprue plate not a mallet…

        #495031
        lwatson
        Participant
          Up
          0
          Down
          ::

          I too hand-open all sprue-levers, give a better finish, but not always easy with certain alloys.

          #495032
          SwedeNelson
          Keymaster
            Up
            0
            Down
            ::

            We offer a set of replacment screws
            http://noebulletmolds.com/NV/product_info.php?cPath=67&products_id=1410&osCsid=1c0r9r03mkb9lqs8n4n7fb0834
            8-32 Set Screws 1/8″ Lng.
            It lists all the sizes needed too

            Bullet maker, maker
            Al Nelson

            #495033
            teemu
            Participant
              Up
              0
              Down
              ::

              Doh  😮 I need glasses…Thanks

              #495034
              lwatson
              Participant
                Up
                0
                Down
                ::

                Yep, that makes two of us  ;)

                #495035
                SwedeNelson
                Keymaster
                  Up
                  0
                  Down
                  ::

                  No problem guys
                  The store is growing and its getting bigger and bigger
                  Can be good and bad

                  Bullet maker, maker
                  Al Nelson

                  #495036
                  Hugh Kuhns
                  Participant
                    Up
                    0
                    Down
                    ::

                    I also have had this problem and to combat it I have taken a cardboard box about 18″ square and cut the sides down to 4″ high. I use this to drop the sprue into and if the set screw falls out it is captured in the box. I also put duct tape on the bottom of the box where the flaps fold over so that no cracks will let that small screw escape. Also have kept the wrench handy to check set screw while casting. It comes loose every now and again because I am afraid to tighten it too firmly and strip the threads …aluminum will only take so much torque.
                      Thanks,sultan

                    762sultan

                    #495037
                    Mike B.
                    Moderator
                      Up
                      0
                      Down
                      ::

                      You might wish to look at this NOE parts intel from the store …”

                      https://noebulletmolds.com/site/shop/bullet-casting-reloading/specialty-moulds/blank-moulds-parts/replacement-screws/

                      Though the screw in question is out of stock the list on that page also lists the intel that you just might find helpful.

                      Take Care, & Stay Safe…

                    Viewing 8 replies - 1 through 8 (of 8 total)
                    • You must be logged in to reply to this topic.