Cheap hardness tester?

Home › Forums › NOE Forums › NOE Archive › Historical Archive › Using NOE Moulds › Casting and Reloading › Cheap hardness tester?

  • This topic is empty.
  • Creator
    Topic
  • 2015-02-03 at 19:08 #487847
    lar45
      Up
      0
      Down
      ::

      I found this old thread at CastBoolits that looks very interesting.  Does anyone know if it really works?
      http://castboolits.gunloads.com/showthread.php?69416-Low-cost-Lead-Hardness-Tester

      Basically it was take and ingot of lead and an ingot of what you want to measure.  Place a steel ball between the two and smack it with a hammer.
      Then measure the indents of both, square the measurements, devide the unknown into the Lead value, then multiply the result by 5 and this should give you the brinell hardness.

      Then another person took a spring loaded center punch to do the same thing…

      Any thoughts on this?

    • Creator
      Topic
    Viewing 4 replies - 1 through 4 (of 4 total)
    • Author
      Replies
    • 2015-02-08 at 00:37 #495994
      cliftonmorris
        Up
        0
        Down
        ::

        There are also people who have worked up a hardness table based on which hardness of artists sketch pencils will mark the bullet. Im sure if you search castboolits you can find it. I think that is probably the most repeatable process. Otherwise the SAECO tester seems to have good reviews but is not cheap at about $150.

        2015-02-09 at 01:02 #495995
        dannyhunley
        Participant
          Up
          0
          Down
          ::

          I use the Lee version.  I have tested it for repeatability and it seems consistent.  It works fine for what I need and the price is reasonable.  Just IMHO.  I hope this helps.

          2015-02-09 at 14:56 #495996
          lar45
            Up
            0
            Down
            ::

            I think that I’ll try to find somone local that has a hardness tester and compare them side by side to see if it is even close.  If not then I’ll just have to get a regular one.

            Thanks
            Glenn

            2015-02-16 at 12:43 #495997
            steveleonard
            Participant
              Up
              0
              Down
              ::

              Going through some old copies I keep of interesting articles this weekend, I found an article on using a staple gun and 3/8″ staples for a hardness tester. I think it was with a model T50. I believe you used a known standard sample of different lead alloys and measured the height of the staple shot into it. This gave a way to compare unknown alloy BHN with known alloy samples BHN.

              EDIT: This was an article in Journal 129, page 15 of “The Cast Bullet” by David Berry, September-October 1997. “The Cast Bullet” was a publication of the Cast Bullet Association prior to “The Fouling Shot”.

              http://castboolits.gunloads.com/showthread.php?7984-Cheap-way-to-test-Lead-Cast-hardness

              Another method is discussed on “The Cast Boolit” forum using various pencils of a particular hardness to estimate the hardness, depending on which pencil hardness designation scratches the alloy.

              http://castboolits.gunloads.com/showthread.php?75455-Testing-hardness-with-pencils

            • Author
              Replies
            Viewing 4 replies - 1 through 4 (of 4 total)
            • You must be logged in to reply to this topic.