358101 75gr WC with crimp groove

Home › Forums › NOE Forums › NOE Archive › Historical Archive › Group Buys › Group Buy Discussions › 358101 75gr WC with crimp groove

  • This topic is empty.
  • Creator
    Topic
  • #488204
    benjaminwolf
      Up
      0
      Down
      ::

      I have a single cavity in this mold and have cast a lot with it in the short time I’ve had it. One thing I’ve played with a bit besides .38 special loads have been .38 Short colt loads. Lots of possibilities there. Would not mind a multi cavity 75gr mold with a crimp groove. I know there is a double lube groove version in the NOE store, has anybody used that just lubing the bottom groove and crimping on the top? or would a 358101 clone be a little better suited?

    Viewing 2 replies - 1 through 2 (of 2 total)
    • Author
      Replies
    • #499545
      SwedeNelson
      Keymaster
        Up
        0
        Down
        ::

        wonderwolf

        I load our little 75gr. WC both ways

        In the top grease groove for revolvers
        An over the nose for autos (S&W52-2, 380LCP)
        Fun little bullet

        Bullet maker, maker
        Al Nelson

        #499546
        benjaminwolf
          Up
          0
          Down
          ::

          I’m new to your molds but I notice when you redesign them you omit the crimp groove in favor of an additional lube groove. Thinking on these little 75gr wadcutters I’m wondering if a heavier crimp would give better ignition for lighter loads perhaps. I’m waiting for the 160gr HP group buy mold to be run as I think I’ll throw one of these molds as you have designed on the order.

        Viewing 2 replies - 1 through 2 (of 2 total)
        • You must be logged in to reply to this topic.