RG operation questions

Home › Forums › NOE Forums › NOE Archive › Historical Archive › General › Forum Questions / Problems › RG operation questions

  • This topic is empty.
  • Creator
    Topic
  • #488250
    mikemaffucci
      Up
      0
      Down
      ::

      I’m awaiting delivery of a Ruger redhawk, one of the new ones with the round-butt grip frame, in 45acp/45colt.

      I have lots of tooling/brass etc. for the 45acp from my IPSC days but have nothing at all for the 45 colt.

      I’m considering getting a mold for 45C and would like it to be in a heavy for caliber boolit with the option for hollow point too.

      How do the RG molds work–do the pins come out with the casting upon opening the blocks?  Or are the pins secured to one of the halves of the mold?

    Viewing 5 replies - 1 through 5 (of 5 total)
    • Author
      Replies
    • #500006
      charlesgilbert
      Participant
        Up
        0
        Down
        ::

        Here are some pictures.
        [urlhttp://noebulletmolds.com/smf/index.php/topic,231.0.html][/url]

        The pins are attached to one side of the blocks by some rails that have slots in them. The pins slide in the rails. The pins tuck into slots in the blocks when the blocks are closed and then they fall/tilt away from the blocks with the bullets and then the bullets fall off the pins. The pins do not come loose from the rails, they only slide/tilt back and forth in the slots.
        I hope that helps.  8)

        #500007
        mikemaffucci
          Up
          0
          Down
          ::

          So, the pins/rails stay with the mould, or do they need to be put back into whichever half they go with?

          Yes I tend to be a bit dense at times…

          #500008
          ringo10x
            Up
            0
            Down
            ::

            the pins stay in one half of the mold.
            when you open the mold, the pins can slide to open position, and the boolits fall out.

            there is probably some youtube video on that.

            #500009
            k7sparky
            Participant
              Up
              0
              Down
              ::

              The RG comes with 3 sets of pins
              HP
              slight concave
              FN
              Gives you 3 great options with one mold
              As stated the pins take a bit of warm up before casting GREAT  ;D hollow points
              The 452-230 RG4 look like flying trash cans.
              I heat moulds on the pot when warming up but still takes 4 or 5 sets to get the pins hot enough.
              Now & then the mould needs a whack with the 1″ dowel I use on the spruce plate to drop one off a HP pin
              I am using a LEE pot and the RG setup didn’t play well in the sand box with the mold support as installed.
              RG mounting holes are symmetric so I swapped pin holder to the other side and it now works great on the LEE mould support
              AND buy the custom nose punch :)

              #500010
              mikemaffucci
                Up
                0
                Down
                ::

                Thanks guys–I have Lee dies and starline brass on the way–Don’t know when the pistol will be in stock at sportssouth but my local(the ONLY) stocking dealer assures me that one WILL be coming in a week or 2.

                I’ll wait to see what the internal dimansions turn out to be before getting sizing/lubing dies.

              Viewing 5 replies - 1 through 5 (of 5 total)
              • You must be logged in to reply to this topic.