Did I order the correct bullet mould?

Home › Forums › NOE Forums › NOE Archive › Historical Archive › General › Forum Questions / Problems › Did I order the correct bullet mould?

  • This topic is empty.
  • Creator
    Topic
  • #488358
    tomfuller
      Up
      0
      Down
      ::

      I finally got around to casting with my new NOE 311299 bullet mould.  It makes beautiful bullets and very easy to use. I got out the bag of NOE gas checks and attempted to install one when I realized that there isn’t a reduced diameter shank to affix the gas check!  Duh!  Did I order the wrong mould or should I just lube them through the .311 sizer and shoot ’em out?  The rifles are ’03 and ’03-A3 Springfields.  Thank you.

    Viewing 2 replies - 1 through 2 (of 2 total)
    • Author
      Replies
    • #500999
      tomfuller
        Up
        0
        Down
        ::

            I answered my own question.. It was the first gas check I ever installed and I got the gas check a little off in the die. After seating it, I noticed that it was cockeyed.  Then I realized that there was no reduced shank like I see in the usual cast bullets for smokeless powder. I “cried before I was hurt”.  The next morning I tried it again, paying attention to get the gas check and bullet properly aligned, seated it and it came out perfect.  Duh!

        #501000
        SwedeNelson
        Keymaster
          Up
          0
          Down
          ::

          MIEagle

          Sorry to take so long to get back to you
          I would need your last name or the last name on the order to confirm
          If you would like to PM it to me I will check on this end too.

          Bullet maker, maker
          Al Nelson

        Viewing 2 replies - 1 through 2 (of 2 total)
        • You must be logged in to reply to this topic.