How about a Hollow Base Keith 358431 clone?

Home › Forums › NOE Forums › NOE Archive › Historical Archive › Group Buys › Group Buy Discussions › How about a Hollow Base Keith 358431 clone?

  • This topic is empty.
  • Creator
    Topic
  • #488495
    micaelnetz
    Participant
      Up
      0
      Down
      ::

      A Hollow Base bullet could be useful for oversize bores or throats/chambers/cylinders, and a .358 could cover a decent range.

      There is the classic Keith design, Ideal/Lyman 358431, that has long been discontinued and long overdue for reintroducing. A far more versatile bullet than a full wadcutter, it could be handy for many different guns, and some that are hard to find a good bullet for.

      It could be based on the regular 358429 (as was the original 358431 I believe) and thus maybe relatively easy to get a production run.

      (I for one could use it in an old Colt Officers Match revolver as well as an obsolete rifle chambered for heeled bullets, both of them indifferent to regular bullets.)

    Viewing 5 replies - 1 through 5 (of 5 total)
    • Author
      Replies
    • #501793
      micaelnetz
      Participant
        Up
        0
        Down
        ::

        This is the regular NOE 360429

        #501794
        erikdorothy
        Participant
          Up
          0
          Down
          ::

          SWEDE: When you get around to looking at this thread, a question for you, since the hollow base question comes up regularly:  Assuming that you were tooled up for a run of SWC’s or WFN’s, and were making your usual offerings of RF solids and RG hollowpoints. . . How much more labor-intensive would it be to run a batch of blocks on the same cavity cutting tools, but reversed for hollow bases?  Could it be done as part of the same setup routine in a way that we could work it into the group buy routine, or is it a TOTALLY different thing?

          Onkel,

          I’m with you in spirit, if not necessarily in caliber.  I’ve got .455 Webley problems to solve – I’d like to HB a good existing flat nose .453″ myself. . .

          Something for you to chew on:  NOE makes a couple of 160 to 180 grain FN and WFN profiles.  The noses on these are shorter than that of the 358429 and do not create the problems of keeping the entire bullet inside the cylinder when seating to the crimp groove in .357 brass.  Might have a little more broad-based appeal.

          #501795
          micaelnetz
          Participant
            Up
            0
            Down
            ::

            Well I could be happy with a round nose design myself (which would get a small flat point), but Keith bullets usually have appeal (and especially “real” Keith bullets), so I figured that would be easier to get going. But this is of course an ongoing discussion so there may be alternatives to consider – like you say for instance a short nose to accomodate short cylinders.

            http://noebulletmolds.com/NV/images/N.O.E._Bullet_Moulds_360_150Gr._RN.Jpg

            #501796
            erikdorothy
            Participant
              Up
              0
              Down
              ::

              http://noebulletmolds.com/smf/index.php/topic,1298.0.html

              Onkel – looks like you got your wish. ;D

              #501797
              micaelnetz
              Participant
                Up
                0
                Down
                ::

                Great, I’m on the list! :)

              Viewing 5 replies - 1 through 5 (of 5 total)
              • You must be logged in to reply to this topic.