Several options really. How I do it is to bring the mold up to casing temp and wipe off with a q-tip. If the lead is so adhered that it will not wipe or fleck off then a copper bristled brush will do it.
You did not state, but I assume you have an Al mold and not a brass mold.
Generally this happens from not having the mold blocks clean and a little lead migrating into it. It can also come from a small piece falling into it, and a host of ‘other’ ways. The lead on top is usually from a poorly tightened sprue plate. Be careful in that if you over-tighten the sprue place it will make the back end push up and worsen the problem. Assuming the plate is flat and not bent, (you can check by removing it and placing on a straight edge ruler, the mold blocks, or flat table). Install it and tighten the screw to the point that it will not fall open by its own weight. back off just a little bit to where it will fall most of or all the way open from its own weight. leave the set screw loose, as once you bring the mold up to full casting temp you will want to make sure it still does the same thing. adjust the screw accordingly and then tighten the set screw.
Note: this is just how I do it, you may find lots of other ways and Sweede may actually have a recommended way as well.
If the cotton bud trick doesn’t lift then I get the mould really hot and then zap the lead spot with a blow torch till it melts and balls and then lift off with a cotton bud.
Lead on the mould faces usually comes from an improperly closed mould or just splashes, on the top tween the sprue plate is usually due to opening the sprue plate whilst the alloy in the mould is still soft and or an improperly fitting sprue plate.
Sprue plat lube applied as directed on the top of the mould and the bottom of the sprue plate will stop smearing but better to wait ’till the alloy has cooled sufficiently.