Nose first or base first sizing for GC seating?

Home › Forums › NOE Forums › NOE Archive › Historical Archive › General › Forum Questions / Problems › Nose first or base first sizing for GC seating?

  • This topic is empty.
  • Creator
    Topic
  • #488823
    davidshimko
    Participant
      Up
      0
      Down
      ::

      I am used to a RCBS sizer, (basically a base first design), and am thinking of also using NOE sizing dies. I size/lube/seat GC all in one motion on the RCBS. My question is:  Will the nose first method of sizing “crimp” on the GC, as the base first method does? I like the flat faced ram design that the nose first method uses. Thanks!

    Viewing 3 replies - 1 through 3 (of 3 total)
    • Author
      Replies
    • #504451
      thomaswarren
        Up
        0
        Down
        ::

        I would like to know this as well, as nobody replied…

        #504452
        robertpedersen1
          Up
          0
          Down
          ::

          With nose-first sizers, at least in my experience, the gas check usually isn’t seated as firmly as with an RCBS/Lyman/Saeco type machine.
          But they seem to be just as square and get crimped on just as well.

          My father uses a Lubri-sizer; and I use push-through dies.
          We’ve never seen any real difference in performance.

          Through experimentation, I have found that nose-first is preferable to base-first when using gas checks in push-through dies.  But, other than that, I don’t consider either method to be inferior. (Until my father over-cranks his lube screw and squirts lube everywhere.  ;D)

          If some one has done a head-to-head comparison of accuracy with the two methods, I’d love to see the data or hear about the results.

          #504453
          Full.Lead.Taco
          Keymaster
            Up
            0
            Down
            ::

            I use the noe die set to seat/crimp gas checks base first.

          Viewing 3 replies - 1 through 3 (of 3 total)
          • You must be logged in to reply to this topic.