- This topic is empty.
-
Topic
-
delbertmccord
I looked around the store and did not see anything in stock for the 300 Blackout. I think around .309 to .311 and around 150 grain. I have a Lee mold (I had to because the NOE website showed out of stock) The Lee mold is dropping boolits to fat in the nose area and I have to load a shorter COL and I do not want to compress the powder. I also am spoiled and just love NOE molds.
I am using H-110 powder and they show 1785 to 1901 FPS so I think I would want a gas check. I powder coat. I have loaded some of the Lee but I do not like the boolit touching the groves (AR-15). I have tried 5 of each and found 15 grain gave me 1861 fps and 15.8 grain gave me 1903. The 15.0 (starting load) gave me my best group. I am only plinking with these I don’t hunt anymore.
delbertmccord-
Replies
-
brigettecuneo
I recently purchased the 311-150-sp plain base for my light 300 blackout loads. Have not got to setting it up and loading some but, you might want to look at that mold. I was also planning on powder coating, and if needed adding a gas check using pop cans. I would say once you get the noe mold, that Lee will start collecting dust. The noe molds really are top notch.
Good luck in your search.
Full.Lead.Taco
toddlaudenbach
I have been using the 311-150-SP 311414 GC mold and have made and fired about 600 of them so far and they are excellent. These molds are actually in stock right now I just checked. I am getting around 1700 FPS, I have been using the GC’s purchased on this site and powder coating them. They shoot excellent out to 300 meters.
Intel6
I have been using the 311-150-SP 311414 GC mold and have made and fired about 600 of them so far and they are excellent. These molds are actually in stock right now I just checked. I am getting around 1700 FPS, I have been using the GC’s purchased on this site and powder coating them. They shoot excellent out to 300 meters.
I just got that mould a while ago and finally got some bullets cast up. I plan on using it in a few different calibers including bolt gun in .300 BO. I am curious what load you are using in .300 BO?
Neal in AZ
sorry haven’t checked the forums on here in a while, I started with H110 ending up at 14.9 grains which is working pretty well out to 300 meters on a 14 inch gong. I just finished a couple test loads using lil gun and have a 3-4 FPS SD (5 rounds) but haven’t shot them for accuracy yet. I will post when I finish testing.
brigettecuneo
toddlaudenbach
Intel6- You must be logged in to reply to this topic.