311-169-FN 5 cavity GC (ELCO)

Home › Forums › NOE Forums › NOE Archive › Historical Archive › Inventory Runs › What you would like to see ran › 311-169-FN 5 cavity GC (ELCO)

  • This topic is empty.
  • Creator
    Topic
  • 2016-09-08 at 23:19 #488896
    Rooman
      Up
      -14
      Down
      ::

      I would like to see the 311-169-FN 5 cavity GC (ELCO) mold made. It has good B.C. and should be great for any .308 rifle. Especially if you are looking to get some long range out of a lead bullet. It says the weight is 171 grains with wheel weights which should put it at about 168 grains if you are using 92/6/2. I also think it would feed good in an AR10. You should be able to heat treat your 92/6/2 alloy to about 25 to 28 BHN and push jacketed bullet velocities. Anyone else interested in this bullet?

    • Creator
      Topic
    Viewing 2 replies - 1 through 2 (of 2 total)
    • Author
      Replies
    • 2016-09-09 at 03:54 #505213
      Hugh Kuhns
      Participant
        Up
        0
        Down
        ::

        I also would like a 311 169 fn 4 cavity aluminum

        762sultan

        2016-09-19 at 13:53 #505214
        Rooman
          Up
          0
          Down
          ::

          Hey 762sultan

          I do not see a 4 cavity in the catalog but I would be happy with a 4 if Swede decided to cut one. I will take a 4 or 5 cavity.
          Surely we can not be the only two wanting a good 308 bullet with great BC.
          Hopefully we can get some more people on board and have Swede do a run.
          You can also go to the “our new wish list” forum and post it there as well.

        • Author
          Replies
        Viewing 2 replies - 1 through 2 (of 2 total)
        • You must be logged in to reply to this topic.