Bullet Diagrams Too Large For Page

Home › Forums › NOE Forums › NOE Archive › Historical Archive › General › Forum Questions / Problems › Bullet Diagrams Too Large For Page

  • This topic is empty.
  • Creator
    Topic
  • #489046
    steveleonard
    Participant
      Up
      0
      Down
      ::

      The bullet diagrams for some .314″/.316″ bullet molds are sized too large for the page. When I look at the page, the noses are cut off. The last one I looked at was the 316-202 but, there’s others.

    Viewing 2 replies - 1 through 2 (of 2 total)
    • Author
      Replies
    • #505844
      Hugh Kuhns
      Participant
        Up
        0
        Down
        ::

        I think that this can be corrected on your computer key board by using the “ctrl”at the lower left of key board. Press and hold it while tapping the + or – key that is located next to the back space key . That will enlarge or minimize the screen size.

        762sultan

        #505845
        SwedeNelson
        Keymaster
          Up
          0
          Down
          ::

          Try clicking on the image.
          It should come up in a box by its self that is readable now.

          Bullet maker, maker
          Al Nelson

        Viewing 2 replies - 1 through 2 (of 2 total)
        • You must be logged in to reply to this topic.