finning at base 358-128 bevel base

Home › Forums › NOE Forums › NOE Archive › Historical Archive › General › Forum Questions / Problems › finning at base 358-128 bevel base

  • This topic is empty.
  • Creator
    Topic
  • #489228
    pauljames
      Up
      0
      Down
      ::

      I’m a newby to aluminum molds, old hand with iron molds. Casting the past couple days with my NOE 358-128 TC bevel base 4 cavity mold. I noticed toward the end of my 2 hour session today I was getting some finning at the base of the bullet. Seems worse on the first hole filled, but was on all 4 cavities. I quit for the day.
      I think my mold may have gotten too hot. Lead temp about 750* PID and a thermometer. Molds preheated on a hot plate and set on hot plate when I added new alloy.
      The finning will be a minor problem when I lube/size them.
      Any input appreciated from the experts!
      Thanks
      Paul James

    Viewing 4 replies - 1 through 4 (of 4 total)
    • Author
      Replies
    • #507560
      adamsutherland
      Moderator
        Up
        0
        Down
        ::

        Check your sprue plate hasn’t slackened off.

        #507561
        Full.Lead.Taco
        Keymaster
          Up
          0
          Down
          ::

          Check your sprue plate hasn’t slackened off.

          Or too tight.

          #507562
          pauljames
            Up
            0
            Down
            ::

            Thanks for the input. I typically run it pretty lose!
            PJ

            #507563
            pauljames
              Up
              0
              Down
              ::

              Checked the mold today cold and it is too loose. I’ll tighten it up for the next session. Thanks for the input!!
              PJ

            Viewing 4 replies - 1 through 4 (of 4 total)
            • You must be logged in to reply to this topic.