Gator checks

  • This topic is empty.
  • Creator
    Topic
  • #489278
    ronreed
    Participant
      Up
      0
      Down
      ::

      The gator checks that I got from NOE will not crimp on my NOE mold bullets, but the Hornady do. Anyone know why? I thought the newer checks were supposed to crimp on.

    Viewing 6 replies - 1 through 6 (of 6 total)
    • Author
      Replies
    • #508030
      adamsutherland
      Moderator
        Up
        0
        Down
        ::

        Are they too big for the shank? What exactly is wrong?

        #508031
        ronreed
        Participant
          Up
          0
          Down
          ::

          They just don’t crimp on. They snap on like the hornady check do, but once run through the sizer they will fall off.

          #508032
          AlvinYork
          Participant
            Up
            0
            Down
            ::

            Are you referring to “crimp on” gas checks, aka plain base gas checks? Are you using these on plain base bullets?

            #508033
            adamsutherland
            Moderator
              Up
              0
              Down
              ::

              You could try annealing some and see if that makes difference, drop some in a pie tin, heat with a gas torch ’til they become that famous “cherry red” and let cool no need to quench.

              That should get rid of any spring back. If that is the issue.

              #508034
              ronreed
              Participant
                Up
                0
                Down
                ::

                The newer Gator checks are supposed to have the lip like the Hornady checks do that maintain a hold on the GC shank of the bullets.

                No, these are GC shank type bullets, not plain base. Specifically .41 cal using both Gator and Hornady .416 checks. The Hornady stay on just fine while the newer Gators still slip off.

                #508035
                Hugh Kuhns
                Participant
                  Up
                  0
                  Down
                  ::

                  Just as Dromia suggested it would be worth a try at annealing those before trying to seat them on a bullet. I have a homemade sizer that is similar to the NOE gas check seater.  My homemade one puts a flair on the top edge of the gas check and when it follows the bullet into the die it crimps onto the bullet base. And I always do this base first. It is tight and can’t be pulled off with a fingernail. I think the NOE system is very similar. And I always anneal my checks in a short piece of black pipe with a cap screwed on each end. Just  throw it in a BBQ pit and take it out in the morning. If you have not been doing this I feel it will help. I’ll never forget when I went to the hardware store to buy those pieces of pipe. The guy behind the counter wanted to know what I was going to use them for. He thought I was making pipe bombs. It took some convincing before he sold them to me.

                  762sultan

                Viewing 6 replies - 1 through 6 (of 6 total)
                • You must be logged in to reply to this topic.