BBT Airgun HPs

Home › Forums › NOE Forums › NOE Archive › Historical Archive › Inventory Runs › What you would like to see ran › BBT Airgun HPs

  • This topic is empty.
  • Creator
    Topic
  • 2017-11-12 at 18:13 #489510
    rsterne
    Participant
      Up
      -11
      Down
      ::

      I have just gone through the Inventory in the NOE Store, and notice that ALL of the commonly used .22 cal and .25 cal Bob’s Boattail Hollowpoint Airgun Moulds have been sold out…. This includes the 0.217/0.219″” and 0.220/0.222″ 30 gr., the 0.250/0.252″ in 41 gr. and 51 gr., and the 0.253/0.255″ in 41 gr. and 51 gr…. If there is anyone interested in seeing these run again, please post in this thread….

      Al, is it possible to drill existing moulds in your Inventory for the Lyman HP pin, or does that have to be done at the time of manufacture?…. There are a few FN moulds left, but no HPs….

      Bob

    • Creator
      Topic
    Viewing 2 replies - 1 through 2 (of 2 total)
    • Author
      Replies
    • 2017-11-13 at 15:42 #509721
      SwedeNelson
      Keymaster
        Up
        0
        Down
        ::

        Bob

        Not set up to run moulds back through the system at this time – sorry
        Lets see what the response is to this thread.
        Can work them in easy enough.

        Working on a run of the .217/.219 now.

        Bullet maker, maker
        Al Nelson

        2017-11-13 at 16:17 #509722
        rsterne
        Participant
          Up
          0
          Down
          ::

          I would go heavier on the HP moulds, they seem to be more popular…. JMO….

          Bob

        • Author
          Replies
        Viewing 2 replies - 1 through 2 (of 2 total)
        • You must be logged in to reply to this topic.