::
The new NOE mould number for that mould 453-210-RF is now a 453-240-RF. That might most probably explain why you are getting 240 Gr cast product weights. An HP version would be closer to 218 to 220 Grains…
That bullet design also has a crimp grove, which a semi auto like a 1911 does not require.
It is what it is…
Looking at the HP, or for that matter the PB version … one will need to also consider nose sizing down that particular bullet so as not to have the loaded round hit the rifling…
Once you nose size the nose … to the crimp grove you may find that your rounds that are hitting the rifling may just go away … as I have seen that issue come up in the past…
Your large meplat still tends to worry me a bit … as that large a meplat tends not to want to feed correctly especially in a goodly number of after market race gun mags.
The race guns tend to have a slightly steeper follower in the mags than the standard GI mags… pointing the round upward … at slightly steeper angle than a normal GI mag does…
That tends to be because the race gun mags are basically optimized for the light weight end of the bullet spectrum … that otherwise might tend to want to hit the feed ramp below the chamber….
That’s also basically why most race guns tend to also have a polished feed ramp…
(The heavy end of the bullet bullet spectrum … in a race gun mag … tends to want to hit the top of the chamber when feeding from those mags)…
That’s also basically why you have to seat that bullet so deep. Once the nose is sized down .001 or .002 to the crimp grove, you can once again assemble a dummy cartridge, & safely check for proper chambering in the 1911 pistol or pistols of your choice…
You may be able to get away with seating to the crimp grove which will give you an ~ .300 SD. Your bullet according to the current NOE dwg … is supposed to have a .600 OAL… The 45 ACP cartridge case is supposed to be ~.898 + .300 = ~ 1.198 which is just short of the SAAMI spec number of ~ 1.275.
I have no idea where you got the 2.225 OAL … as that would be a whole lot longer than the normal 45 ACP cartridge that the 1911 normally is setup for… Is that number actually 1.225 perhaps?
Once you get the assembled dummy rounds to cycle & chamber properly, the OAL can be measured on the round or rounds that will chamber. Then, one can input the data into Quickload.
Once you have that; the load intel for a variety of powders can basically be predicted…. including the powder that you referenced…
I can’t comment on the manuals that you got your basic intel from … as you did not reference that basic intel…
https://noebulletmolds.com/site/453-210-rf-bd/
Take Care, & Stay Safe…