I have a casting pot guide idea.

Hey all,

I just got the NOE mould guide to go with a new Lyman pot. I was wondering what some you think of this idea. Take the current mould guide, and raise a shelf on the right side of it to allow the mould to be held in a level position when casting. What I mean is that the mould would sit on the guide flat, and not tilt to the right, make sense?

I do not know if anyone else has had this issue, I do have an issue with my hands, might be where the real problem lies. I was thinking about this last night as I looked at it. I measure the difference at .19″, IDK, is this milled out of material that would allow for a custom guide to be made?

I just went down and looked at it, I guess maybe the better thing might be for me to drill and tap the mould for two button head screws opposite the pin screws

Or, maybe I just need to tighten the main screw some.