New run of: 253-52-FN-BB4 5 Cavity ?

You might want to get those individuals to also sign in and post their requests for a new run of this particular mould…

https://noebulletmolds.com/smf/index.php/topic,1624.0.html

This mold is perfect for the huben k1. I would like one for sure in 5 cavity:-)

There are still no 5 cavity moulds in stock of the Lyman variety HP version …

However there is apparently still some stock of that particular mould as noted in the recently added products to that NOE inventory page… in two cavity brass and steel versions, along with a four cavity brass version.

https://noebulletmolds.com/site/recently-updated-products/

Noted below is the description of the 5 cavity version description…
253-51-FN 5 cavity BT w/ HP This is a HP like the Lyman removable Single pin system. Use single pin for HP or FN

Take Care, & Stay Safe…

NVshooter

For that you will need to get at least 10 more individuals to request that particular mould in that cavity count… to get a new mould run of RG4 NOE HP moulds designed and run…

The fact that there are a goodly number of non hollow point versions left of that mould when a large number of mould bins are completely empty… May just be a factor here… When a whole lot of other mould bins are empty…

Did you notice that the 253-52-FN five cavity mould design is only a single cavity Hollow Point Lyman style HP Pin?

Apparently from what I can research this particular design has never been apparently been run as an  RG4 may also be a factor here…  (four cavity hollow point)

Only one cavity of the five is a hollow point… the other four are are flat points … which is the same as what is currently in stock … and have no hollow point feature…

I don’t work for NOE … I am a member just like you are… who casts what tends to be needed  …

I just tend to look and see what potentially might be available, & then if I can get it modified by another source to what I want… I purchase the NOE mould and then have it set & modified to be an HP version…

Once I have the arrangement made to get the mould modified to what I need … I then go ahead and purchase the mould from NOE …

It may cost more up front … but to get what one wants … sooner rather than later … to me the cost vs the potential wait … is worth it…

Your call on how you want to proceed… You may or may not agree…

Take Care, & Stay Safe…