403 198 wfn hp

Did you mean the N.O.E. 403-198-WFN mould?
You also mentioned HP RG2 (2 cavity) or RG4 (4 cavity)
Brass or Aluminum ?
Finally GC or PB… ?

The above intel tends to help others that might possibly also want a new run of the same previously run mould design.

https://noebulletmolds.com/site/product-category/bullet-moulds/401/403-198-wfn-y1/

Take Care, & Stay Safe…

Thanks for the updated reply…
I am also interested in that particular mould, which is basically why I asked …about that specific mould.
Noted below is what I tend to believe from your reply that we are looking at so far…
We will most probably need at least three more individuals to request a new run in a very short time according to the posted NOE requirements noted below for requesting new inventory runs… More individuals wanting this particular mould would tend to be even better …

https://noebulletmolds.com/smf/index.php?topic=1624.0

1. Mainiac                        403-198-WFN  RG4  PB  Aluminum        04-28-22
2. Mike B.                        403-198-WFN  RG2  PB  Aluminum        04-28-22

You might want to then change the Subject: title on the string on future replies to the 403-198-WFN so that others who might also be interested, can more easily find your request.

It just needs to be typed in on the replies up in the title string, just as I have done above…

You can also go back to your original request & replies and modify the title string… and then save once again.

Your call on that detail …

Take Care, & Stay Safe…