- This topic is empty.
-
Topic
-
RevRich
I just got my new Impact M3 and I must say I love this rifle. I was only able to find the hybrid slugs though. After zeroing the scope the gun stacks the slugs all day long.
I want to purchase a 300-46-RF-CC4 mold and was wondering if anybody has Impact M3 tuning settings for this bullet.
Also, do the cast pellets need to be sized? If so, would the correct size die be .308?
RevRich
-
Replies
-
Mike B.
There appear to be 7 of the Aluminum 2 cavity in stock, & 9 of the Brass 2 cavity version in stock of your 300-46-RF desired moulds.
https://noebulletmolds.com/site/product-category/308-311/300-46-rf-cc4-hunter-pellet/
The airgun portion of your questions in regard to the air gun settings & sizing dia’s, most probably need to be addressed by the air gun guru in Canada…
Since it is now early evening in Canada, or very close to it… hopefully he will respond…
Take Care & Stay Safe…
rsterne
The NOE pellets shoot well as cast, that is how they are intended to be used…. The head diameter is 0.300″ and the skirt 0.308″, the same as JSB pellets…. I have never sized any pellets, the only way to do it would be a tapered sizing die with a stop to prevent them from going right through and sizing the skirt way too small….
Bob (in Canada)
FXM3.30
There appear to be 7 of the Aluminum 2 cavity in stock, & 9 of the Brass 2 cavity version in stock of your 300-46-RF desired moulds.
https://noebulletmolds.com/site/product-category/308-311/300-46-rf-cc4-hunter-pellet/
The airgun portion of your questions in regard to the air gun settings & sizing dia’s, most probably need to be addressed by the air gun guru in Canada…
Since it is now early evening in Canada, or very close to it… hopefully he will respond…
Take Care & Stay Safe… unfortunally the 4 cavity is sold out…
[/quoteu
FXM3.30
There are still 5 of the Aluminum 2 cavity & 8 of the 2 cavity Brass that still appear to be in stock… as of 12-1-2021.You are correct that the 4 cavity has been apparently sold out for quite a while now…
You may want to read the NOE inventory request requirements that NOE has had posted for a goodly while now…
I believe that I also posted a link to that topic a short while back…
You can of course request a 4 cavity run with at least 4 other members …
I can add you to my unofficial listing as a request for a 4 cavity run…
However with moulds still in stock, all be it in two cavity moulds, not four …. One might tend to doubt that a 4 cavity run will be high on the priority listing … for a new run…
You might also call Al, & see what he says … in that regard…
Your call on how you want to feed your airgun …
Take Care, & Stay Safe…
Mike B.
rsterne
FXM3.30
- You must be logged in to reply to this topic.