TL314-75-RF (RD) 32ACP

Up

-8

Down

::

I’m new here but I would like to see this mold offered again.

I shoot 32 ACP out of a couple of different guns and there aren’t many choices for cast out there.

Topic

[AlvinYorkParticipant]

Up

0

Down

::

It appears Al has a couple of these moulds in 2-cavs . . . RG no less. Or were you looking for a bigger mould?

[eddymartinezSpectator]

Up

0

Down

::

Alvin,

Did the TL314-78-RF-BD5 RG2 cavity PB (RD) replace the -75? 
I’d rather have 4 or 5 cavities. But, that HP may be something to consider…
I have the Lyman 311252 in 2C as well.

Thanks.

[AlvinYorkParticipant]

Up

0

Down

::

Yes, I think that’s the case. I have the Lyman mold and this one which does not produces the same bullet. This one produces a bullet designed by Ranch Dog who doesn’t stop by very often anymore.
I know what you mean about wanting 4 or 5 cavities. Those cook up a mess of bullets pretty quickly. But my advice to people on the edge of buying a mould or not is to keep in mind Al’s got a small shop (no offense Al) so it may be a while before he swings back this way and runs a new batch. So my advice, in general and not limited to this specific case, is that if it’s something you want but not exactly the right configuration, buy it, because if someone else does now you have to wait. My other piece of advice to people is to buy brass, if possible, because they usually survive an accident that would render an aluminum mould unusable. And that’s about all the advice I give on this forum.

[Author]

Replies