Pin on bracket HP issue

Home › Forums › NOE Forums › NOE Archive › Historical Archive › Using NOE Moulds › Casting and Reloading › Pin on bracket HP issue

  • This topic is empty.
  • Creator
    Topic
  • 2014-08-06 at 16:40 #487500
    reynaldosolis
    Spectator
      Up
      0
      Down
      ::

      I read the thread explaining how to adjust the hollow point brackets for pins seating too high. My 358-135G-FN 2 cavity mold has 1 pin that sits too low. I consistently get a raised lip around the hollow point. How do I go about fixing this? I could post a picture after I get home if it’ll help.

    • Creator
      Topic
    Viewing 3 replies - 1 through 3 (of 3 total)
    • Author
      Replies
    • 2014-08-06 at 16:49 #492861
      reynaldosolis
      Spectator
        Up
        0
        Down
        ::

        I guess I will double check that I can’t make an adjustment to raise the pin and report back tomorrow.

        2014-08-06 at 16:59 #492862
        SwedeNelson
        Keymaster
          Up
          0
          Down
          ::

          Soless

          Check and make sure that you haven’t got anything between the bracket and the block.
          And make sure that the bracket is not bent down too much.
          May have to adjust the bracket up if it is too far down.

          Hope this helps
          Bullet maker, maker
          Al Nelson

          2014-08-07 at 02:25 #492863
          reynaldosolis
          Spectator
            Up
            0
            Down
            ::

            I’m pleased to report after making that small adjustment, the pin seats just perfect now. Not only that, but the more I use the mold the easier is for the bullets to drop.

          • Author
            Replies
          Viewing 3 replies - 1 through 3 (of 3 total)
          • You must be logged in to reply to this topic.