Pin on bracket HP issue

Up

0

Down

::

I read the thread explaining how to adjust the hollow point brackets for pins seating too high. My 358-135G-FN 2 cavity mold has 1 pin that sits too low. I consistently get a raised lip around the hollow point. How do I go about fixing this? I could post a picture after I get home if it’ll help.

Topic

[reynaldosolisSpectator]

Up

0

Down

::

I guess I will double check that I can’t make an adjustment to raise the pin and report back tomorrow.

[SwedeNelsonKeymaster]

Up

0

Down

::

Soless

Check and make sure that you haven’t got anything between the bracket and the block.
And make sure that the bracket is not bent down too much.
May have to adjust the bracket up if it is too far down.

Hope this helps
Bullet maker, maker
Al Nelson

[reynaldosolisSpectator]

Up

0

Down

::

I’m pleased to report after making that small adjustment, the pin seats just perfect now. Not only that, but the more I use the mold the easier is for the bullets to drop.

[Author]

Replies