- This topic is empty.
-
Topic
-
I just receiving the NOE push through sizer and I’m having a little trouble with it.
First, the base part (not sure exactly what it’s called but it slips into the ram where shellholders and the push rods normally go) is super tight. It’s tight enough I had to use a rubber hammer to tap it in and out, can’t remove or install it by hand. I took calipers to the 22 caliber base push rod and it looks like the bottom rim of the nose sizing base-thingy is 0.01″ taller. I should have checked the ODtoo but I didn’t.
Second, I installed the rcbs/lyman style nose sizing punch I got with my Mihec 223 mold and snugged down the set screw just finger tight, didn’t crank on it or anything. Now, even with the set screw removed, I can’t get the sizing punch out. I really don’t want to take pliers to it and mess things up.
Any ideas on how to fix these two problems?
- You must be logged in to reply to this topic.