Nose sizing punch stuck in base of push through sizer?

Home › Forums › NOE Forums › NOE Archive › Historical Archive › General › Forum Questions / Problems › Nose sizing punch stuck in base of push through sizer?

  • This topic is empty.
  • Creator
    Topic
  • #489043
    tylercrowe
    Participant
      Up
      0
      Down
      ::

      I just receiving the NOE push through sizer and I’m having a little trouble with it.

      First, the base part (not sure exactly what it’s called but it slips into the ram where shellholders and the push rods normally go) is super tight. It’s tight enough I had to use a rubber hammer to tap it in and out, can’t remove or install it by hand. I took calipers to the 22 caliber base push rod and it looks like the bottom rim of the nose sizing base-thingy is 0.01″ taller. I should have checked the ODtoo  but I didn’t.

      Second, I installed the rcbs/lyman style nose sizing punch I got with my Mihec 223 mold and snugged down the set screw just finger tight, didn’t crank on it or anything. Now, even with the set screw removed, I can’t get the sizing punch out. I really don’t want to take pliers to it and mess things up.

      Any ideas on how to fix these two problems?

    Viewing 2 replies - 1 through 2 (of 2 total)
    • Author
      Replies
    • #505840
      Hugh Kuhns
      Participant
        Up
        0
        Down
        ::

        I have had some similar problems in the past. It seems that their machining tolerance is so precise that some components won’t work without binding. I have lightly relieved  the inside edge of one piece and lightly rounded off the edge on the other piece and then polished all pieces that touch each other with Mothers Mag Wheel Polish. Just remember just the edge and not everything…that will change the inside diameter of the sizer.  Also I have had to use a very fine automotive type sandpaper on one sizer. And I usually use STP very sparingly. They work very well once you get them all smoothed up.

        762sultan

        #505841
        tylercrowe
        Participant
          Up
          0
          Down
          ::

          I figured a slight polishing on the punch might prevent binding again. I was initially irritated but that quickly changed to appreciation at the tolerances involved. There’s still the issue of the base being a bit too thick where it fits in the ram. I might chuck it up in the mini lathe and take of a couple thous

        Viewing 2 replies - 1 through 2 (of 2 total)
        • You must be logged in to reply to this topic.