Home › Forums › NOE Forums › NOE Archive › Historical Archive › Using NOE Moulds › Air Guns › Machining leftovers.
- This topic is empty.
-
CreatorTopic
-
2018-07-19 at 23:55 #489723
-
CreatorTopic
-
AuthorReplies
-
2018-07-20 at 12:52 #511088
Hugh Kuhns
Participant::I’m not sure from the photo if that is a machining problem. That looks like lead deposits around the sprue plate holes. And I noticed that the sprue plate has been reversed and has drag marks from use…in both positions. Are you using proper lubrication? I would suggest that the mould be taken apart and cleaned and done in the way suggested by NOE…hot water, toothbrush and dish soap. Carefully clean the lead deposits from the sprue plate and mould surfaces with a wooden popsicle stick, or wooden kitchen match…never use a metal instrument. Once clean lube with NOE lube that came with it when new. Check the sprue plate tightness. It should be able to move back and forth on it’s own weight and swing freely. If it is not as I described, but a mould imperfection, you should contact Al at NOE for his expert opinion and solution.
762sultan
2018-07-20 at 15:24 #511089rsterne
Participant2018-07-20 at 16:52 #511090Hugh Kuhns
Participant2018-07-20 at 21:41 #511091tnt76
::It’s not lead deposits, it is flashing, as it was there before use. I have prepped the mold according to NOE guidelines before use also. The darker marks are from the sprue plate, which I think is from smoking the cavities and dragging the soot. And the sprue plate has been reversed so that my temp probe lead can be taped to the handles, however I did do a preliminary casting beforehand.
As Bob has also experienced, it is machining flashing.
I will wait for Al’s recommendation also, or just do as Bob did.250-34 pellet mold by the way.
2018-07-21 at 21:08 #511092SwedeNelson
Keymaster::tnt76
A good cleaning with a tooth brush will get about 80% of the burrs off.
The balance you can get with your thumb nail or a round tooth pick.
The real bad places I use a copper penny.
I don’t like to use a file or even a diamond file – it takes to much off to fast.
Slow and easy is what I look for.
We try to get them cleaned up before we ship them, but some get through – SorryYou can send it back and will fix it.
Bullet maker, maker
Al Nelson2018-07-22 at 03:57 #511093tnt76
2018-07-29 at 08:12 #511094michaellovett
2018-08-08 at 05:13 #511095tnt76
::So I have done as suggested, and worked over the mold to rid it of the machining dags, starting with the side of a plastic paint scraper and broke the chips off with a back and forward technique, then wrapping a 1/16 drill bit with 400grit wet and dry sandpaper and spinning by hand, while maintaining the curved profile of the head of the pellet. Then polishing with some scotchbrite style fine cloth by hand. It now looks almost flawless.
And while also adding a 1.5 degree leade to the marauder (to suit the 50gr BBT’s), and casting a new batch of these 34.4gr in pure lead, my 50 meter groups have shrunk from 4-6″ to around 1″, much happier now. Bases are not perfect either, so I might play a bit more with casting temp, currently at 750f and mold temp floating around 400f – 415f, also the pins heated with butane torch.Looking promising.
-
AuthorReplies
- You must be logged in to reply to this topic.
