224-60-FN (Bob’s Boat Tails)

This topic is empty.

Creator

Topic
2015-10-17 at 21:58 #488351
SwedeNelson
Keymaster
Up
0
Down
::
Working with rsterne (Bob’s Boat tails) on some Air rifle moulds
We have come up with the following design
8.5″ Twist

Post if you have any interest and will see what we can do.

Bullet maker, maker
Al Nelson
Creator

Topic

Viewing 6 replies - 1 through 6 (of 6 total)

Author

Replies
2015-11-25 at 18:44 #500965
teemu
Participant
Up
0
Down
::
Interested
2016-10-26 at 17:19 #500966
rsterne
Participant
Up
0
Down
::
I’m interested, particularly if a HP version can be made….

Bob
2016-10-26 at 17:21 #500967
teemu
Participant
Up
0
Down
::
I think we are on thin ice with this one bob…No love for this one :'(
2018-10-28 at 22:26 #500968
rsterne
Participant
Up
0
Down
::
I just found out that TJ’s has a 9″ twist barrel available…. I think that might be OK for this bullet…. I plan to assemble a gun around that barrel, so if we can get some interest in this bullet we may have a good combination for a long range PCP without having to resort to extreme pressures…. 3000 psi should be enough with a 28″ barrel to reach into the mid 900s….

Bob
2019-03-08 at 03:57 #500969
rsterne
Participant
Up
0
Down
::
How about making this mould as the RG2 and RG4 with HP in all cavities?…. I’d take an RG4….

Bob
2019-08-12 at 18:55 #500970
rsterne
Participant
Up
0
Down
::
NOTE:

Based on the results of the .308 cal 154 gr. BBT, which has identical proportions, there is a good chance that this bullet would be usable in a 10″ twist….

Bob
Author

Replies

Viewing 6 replies - 1 through 6 (of 6 total)

You must be logged in to reply to this topic.