250-51-FN (Bob’s Boat Tails)

Home › Forums › NOE Forums › NOE Archive › Historical Archive › Air Rifle Moulds › (AR) Group Buy Discussions › 250-51-FN (Bob’s Boat Tails)

  • This topic is empty.
  • Creator
    Topic
  • 2015-10-17 at 21:45 #488343
    SwedeNelson
    Keymaster
      Up
      0
      Down
      ::

      Working with rsterne (Bob’s Boat tails) on some Air rifle moulds
      We have come up with the following design
      16″ Twist – fits Hatsan & Marauder Magazines

      Post if you have any interest and will see what we can do.

      Bullet maker, maker
      Al Nelson

    • Creator
      Topic
    Viewing 4 replies - 16 through 19 (of 19 total)
    1 2
    • Author
      Replies
    • 2017-03-13 at 04:59 #500911
      rsterne
      Participant
        Up
        0
        Down
        ::

        Scott…. You can size your bullets down, in 0.001″ increments, by using NOE’s sizing die in any conventional reloading press, such as the inexpensive Lee…. Here is a link to the body sizing die and bushings…..

        http://noebulletmolds.com/NV/index.php?cPath=104

        When I was referring to the barrel being “choked” I mean that the muzzle portion is slightly smaller than the remainder of the barrel…. I understand the AirForce barrels are choked in this way…. I know that several people with AirForce barrels have shortened them to remove the choke for shooting bullets…. I do not know if that is necessary, as I stated earlier….

        Bob

        2018-03-29 at 18:33 #500912
        alejandroroque
          Up
          0
          Down
          ::

          First time here.

          I just ordered a mold or mould and realized it will not fit my hatsan; so, canceled the order.

          Then went to check for the 250-41-FN 4 cavity BT, and there is ‘0″ available.

          Any idea when will it be back, or if it will?

          Thank you.

          2018-03-29 at 18:49 #500913
          rsterne
          Participant
            Up
            0
            Down
            ::

            Drill Dog, I started a thread here for you to express your interest in an Inventory Run….

            http://noebulletmolds.com/smf/index.php/topic,2494.0.html

            Bob

            2018-05-05 at 03:42 #500914
            rsterne
            Participant
              Up
              0
              Down
              ::

              These are now back in stock in the Store…. Thanks, Al….

              http://noebulletmolds.com/NV/index.php?cPath=374_376_468

              Bob

            • Author
              Replies
            Viewing 4 replies - 16 through 19 (of 19 total)
            1 2
            • You must be logged in to reply to this topic.