.266-126 FN for 6.5 Creedmoor

Home Forums NOE Forums NOE Archive Historical Archive Using NOE Moulds Favorite loads .266-126 FN for 6.5 Creedmoor

  • This topic is empty.
  • Creator
    Topic
  • #490242
    Scott Dusang
      Up
      0
      Down
      ::

      I’ve searched and found other 6.5 loads (6.5 Grendel, Swede etc.) but not for Creedmoor. I know the 10 grain is more geared for the CM but just seeing what’s out there for the 266/126 gr FN.

    Viewing 3 replies - 1 through 3 (of 3 total)
    • Author
      Replies
    • #512973
      Mike B.
      Moderator
        Up
        0
        Down
        ::

        Maybe you should try looking at Load Data… 

        https://loaddata.com

        I just looked, & found at ~ twenty different 6.5 MM Creedmoor articles with some where around 1000 loads listed…

        Also Hodgdon Rifle Reloading data center has ~ 194 loads listed from 95 Grains to 153 Grains from five different powder manufacturers…

        https://www.hodgdonreloading.com/reloading-data-center?rdc=true&type=54

        Take heart the loads are out there…

        Unfortunately the NOE forum is apparently still not allowing postings of items such as load data as attachments … thus the links to the afore mentioned intel… are noted above

        Take Care, & Stay Safe…

        #512974
        Scott Dusang
          Up
          0
          Down
          ::

          Thank you Mike.

          #512975
          Mike B.
          Moderator
            Up
            0
            Down
            ::

            You are welcome.
            I didn’t appear see a preferred powder mentioned in your first posting. I also have quickload and the aforementioned bullet setup in that system… Unfortunately NOE PM’s also do not allow for attachments…
            Only emails… at the moment allow for attachments.
            Pictures like .pdfs & or .jpgs tend to make up for more than 1000 words…
            Take Care, & Stay Safe…

          Viewing 3 replies - 1 through 3 (of 3 total)
          • You must be logged in to reply to this topic.