357-156-FN (Bob’s Boat tails)

Home › Forums › NOE Forums › NOE Archive › Historical Archive › Air Rifle Moulds › (AR) Group Buy Discussions › 357-156-FN (Bob’s Boat tails)

  • This topic is empty.
  • Creator
    Topic
  • 2015-10-13 at 16:06 #488319
    SwedeNelson
    Keymaster
      Up
      0
      Down
      ::

      Working with rsterne (Bob’s Boat tails) on some Air rifle moulds
      We have come up with the following design
      23″ Twist



      Post if you have any interest and will see what we can do.

      Bullet maker, maker
      Al Nelson

    • Creator
      Topic
    Viewing 2 replies - 1 through 2 (of 2 total)
    • Author
      Replies
    • 2016-05-28 at 12:25 #500808
      garrettthibualt
        Up
        0
        Down
        ::

        This mold has my interest too. Leaning toward the 178 grain but will have to await field reports to know which will suit the gun better.

        With either of these molds in a group buy is it any problem if the group wants to go to .358 or even .359 diameter? I’m fine with sizing a slug but it’s hard to get them to grow and there are those that use harder alloy. These specs are for pure lead to drop at .357 right?

        2016-12-18 at 17:40 #500809
        tomkerrigan
        Participant
          Up
          0
          Down
          ::

          I have three guns with 22″ twist, so I will take a two cavity alum. if they ever get made.  Regards, Tom

        • Author
          Replies
        Viewing 2 replies - 1 through 2 (of 2 total)
        • You must be logged in to reply to this topic.