357-178-FN (Bob’s Boat Tails)

Home › Forums › NOE Forums › NOE Archive › Historical Archive › Air Rifle Moulds › (AR) Group Buy Discussions › 357-178-FN (Bob’s Boat Tails)

  • This topic is empty.
  • Creator
    Topic
  • #488348
    SwedeNelson
    Keymaster
      Up
      0
      Down
      ::

      Working with rsterne (Bob’s Boat tails) on some Air rifle moulds
      We have come up with the following design
      20″ Twist


      Post if you have any interest and will see what we can do.

      Bullet maker, maker
      Al Nelson

    Viewing 6 replies - 1 through 6 (of 6 total)
    • Author
      Replies
    • #500954
      moomoo
        Up
        0
        Down
        ::

        I would buy a 2 cavity mold, whit one HP and one normal cavity

        Thx Maarten

        #500955
        SwedeNelson
        Keymaster
          Up
          0
          Down
          ::

          moomoo

          Would be on our RG2 cavity mould blocks
          Will come with HP, FN and Cup Point pins.

          Bullet maker, maker
          Al Nelson

          #500956
          garrettthibualt
            Up
            0
            Down
            ::

            I’m interested in this mold. RG2 mold if I’m reading that right would be best. Pins for flat or HP options sounds perfect.

            If the new Airforce comes in as predicted this may be the ticket. 900 fps game stopping slug is just what I had in  mind. From what I can tell, read, a wide shallow HP with up to 2 % tin alloy should expand and not fragment at that velocity.

            #500957
            rsterne
            Participant
              Up
              0
              Down
              ::

              I would use the deep HP (shown) on lighter game, and the shallower cup point for deer and such…. The RG kit comes will all three sets of pins, HP, CP, and FN….

              Bob

              #500958
              timagnew
              Participant
                Up
                0
                Down
                ::

                I’m in for a rg4

                #500959
                tomkerrigan
                Participant
                  Up
                  0
                  Down
                  ::

                  I’m in for a RG-2 Alum.  Regards, Tom

                Viewing 6 replies - 1 through 6 (of 6 total)
                • You must be logged in to reply to this topic.