452-230-HP RG2 cavity PB & 452-230-HP (Small) RG2 cavity PB question

Home › Forums › NOE Forums › NOE Archive › Historical Archive › General › Forum Questions / Problems › 452-230-HP RG2 cavity PB & 452-230-HP (Small) RG2 cavity PB question

  • This topic is empty.
  • Creator
    Topic
  • #488956
    Rooman
      Up
      0
      Down
      ::

      I have been looking at these two molds. Both are showing three sets of pins and a cast weight of 232 grains using wheel weights. I am assuming that the 232 grains is for the solid flat point. Does anyone know what the different weights are for these two molds using the different hollow point pins? Weights in 30 to 1 lead (97% lead, 3% tin) would be preferred but if anyone has info using wheel weights that is fine too. I am hoping one of the hollow points would cast at about 200 grains with 30 to 1 lead. Any help would be appreciated.

    Viewing 2 replies - 1 through 2 (of 2 total)
    • Author
      Replies
    • #505499
      brigettecuneo
      Participant
        Up
        0
        Down
        ::

        The 452-230-hp large drops boolits just over 230. The solid is around 240ish. In the small hole design, each is alittle heavier then that, respectively.
        You might want to look into the 453-220-RF
        It can make round nose, flat point and hollow points. The HP drop right a 200 grains. Round nose just about 228 grains.
        Hope that helped.

        #505500
        Rooman
          Up
          0
          Down
          ::

          Thanks for the help Mountain Man. I will take a look at the mold you suggested.

        Viewing 2 replies - 1 through 2 (of 2 total)
        • You must be logged in to reply to this topic.