460-186-CB

  • This topic is empty.
  • Creator
    Topic
  • #488801
    jimmckee
      Up
      0
      Down
      ::

      Anyone using this boolit in the 45-70? How does it perform?
      Thanks!
      Jim

    Viewing 9 replies - 1 through 9 (of 9 total)
    • Author
      Replies
    • #504350
      Intel6
      Participant
        Up
        0
        Down
        ::

        I am using it as a plinker in my 1895 GBL. 10 grs. of UNQ will push it to just under 1,000 fps and it makes a great 50 yd. round.

        I had issues with running it through my Star lubesizer so now I just Hi-Tek coat them and run them through my NOE push through sizer.

        Here is a pic of the bullet and it loaded into a 45-70 case along with some others. Not sure why the pic turned out a bit funny looking?

        Bronze_500.jpg

        #504351
        Irascible
        Participant
          Up
          0
          Down
          ::

          Did some shooting with this bullet today tried 10, 11 and 12 gr of Green Dot shotgun powder. I had feeding problems in the Marlin 1895 CB, but it shot well with no sign of pressure. Then I tried my Williams sighted 1885 Browning single shot which put 4 shots into 2″ at 50yds and that included 8 clicks of elevation change and 4 clicks of windage. This is almost more accuracy then I expected. More experimentation to come.

          #504352
          Intel6
          Participant
            Up
            0
            Down
            ::

            I have not had any issues with the bullet loaded in the case like in the picture.  I shoot them in my 1895 SBL with no issues? 

            #504353
            mattoverhage
            Participant
              Up
              0
              Down
              ::

              Same here, no problems at all cycling. So far I’ve used 21gr of 4227 which was OK but I want something a bit lighter. Loaded up 2 rounds with 14gr of Unique, haven’t tried them yet. Caught the 10gr of Unique that Intel6 tried, that I’ll need to try out. The 4227 load kicked like a factory 44mag in my lever gun, and the noise was a bit much. I’ve tried 11gr of Unique with the 405gr, now that was fun but a bit to much lead to send down range.

              #504354
              mattoverhage
              Participant
                Up
                0
                Down
                ::

                Tried the 14gr of Unique this morning, it was OK I guess but I want something even lighter. Went in my room and loaded 2 with 10gr of Unique and used them, now that’s what I’m looking for. Accuracy I have no clue yet, right now I’m after recoil, but accuracy will be tried next. Now I need to find a substitute for Unique, I don’t have much left of that.

                #504355
                Irascible
                Participant
                  Up
                  0
                  Down
                  ::

                  I shot some more with the Williams sighted 1885 and the collar button loads. 12 gr of Green Dot in 7 shots gave an average velocity of 1533 fps with a standard deviation of 11. Very light kick and all 7 went into a center to center group 3/4″wide by 7/8″ high at 50yds. Very clean burning and no leading.
                  I only used a bag of plastic pellets from a bean bag chair, perched on top of a cement block as a front rest. I’d bet if I put the scope back on and used my good rests this combo will shoot less than an inch at 100. I say that, but I really don’t know how this bullet will stabilize at further distances. We’ll see.

                  #504356
                  Full.Lead.Taco
                  Keymaster
                    Up
                    0
                    Down
                    ::

                    I’ve shot hundreds of these little bullets in my 45-70’s.  They make a very excellent plinker bullet.  10 gr unique is a nice light load & 13 gr red dot sends it out a little faster.  I was playing with a harder alloy and powder coated the bullets and loaded them with around 35 gr 5744 to get them flying out a bit faster still.  They are a hoot in my BFR as well as my levers and single shots.  Really fun on steel.

                    #504357
                    Irascible
                    Participant
                      Up
                      0
                      Down
                      ::

                      I took the 1885 to the range to try the CB at 100yds. It took 66 clicks on the Williams to bring it down from it’s 200yd setting with a 405gr bullet. I’m happy to report that all bullets went straight through with no tipping.

                      #504358
                      Full.Lead.Taco
                      Keymaster
                        Up
                        0
                        Down
                        ::

                        I’m feeling like throwing on a PB gas check with a hard alloy & powder coat and letting these things fly fast.  No real good reason as to why, other than just because I want to.  I know it won’t be a good long range bullet or anything like that–I just want to play and see how it goes.  If I get some spare time, I will try it and post results.

                      Viewing 9 replies - 1 through 9 (of 9 total)
                      • You must be logged in to reply to this topic.