ALLEN WRENCH SIZES ?

Home › Forums › NOE Forums › NOE Archive › Historical Archive › General › Forum Questions / Problems › ALLEN WRENCH SIZES ?

  • This topic is empty.
  • Creator
    Topic
  • #488631
    gwpercle
    Participant
      Up
      0
      Down
      ::

      I need to buy several Allen wrenches for my mould,  I keep loosing and or misplacing them,  I just lost the small one for the set screw ,  I put it in my pocket so I wouldn’t loose it…I lost It!
      I believe the large wrench  is 1/8th inch .  But the small wrench ,  that fits the set screws ,  is the one I need to know the size of.
      I’m going to find a place that will sell individual wrenches,  I don’t need another set of the darn things ,  then I’m going to buy a half dozen of each size ,  and see if I can devise a way of keeping both of them with the mould. 
      You can’t tighten the big ones unless you got a small one to back out the set screw.    What I need is a double ended Allen wrench !
      I think the small wrench  I put in my pocket went into that black hole where only one sock disappears to.
      Gary

    Viewing 3 replies - 1 through 3 (of 3 total)
    • Author
      Replies
    • #503206
      SwedeNelson
      Keymaster
        Up
        0
        Down
        ::

        gwpercle

        1/8″ (.125) and 5/64″ (.078) Allen wrench’s

        Bullet maker, maker
        Al Nelson

        #503207
        Hugh Kuhns
        Participant
          Up
          0
          Down
          ::

          I had the same problem until I went to the parts store and bought 1/4″ drive sockets that fit onto a nut driver in my 1/4 ” drive socket set. They are large enough that they don’t fit in a pocket. I keep them in a cardboard box that is on the casting table with other things like mould lube, Q-tips, several screwdrivers, flux, small crescent wrench for adjusting the hollow point pins, etc. The sockets are only about $3 so it won’t break the bank. Just be careful not to over tighten them as the sockets have a lot of power and might strip the threads. :)

          762sultan

          #503208
          gwpercle
          Participant
            Up
            0
            Down
            ::

            Wow , you quick !  Appreciate the quick  reply.  I’m sure you get tired answering that but the search function turned up zilch and none were sold at the store.
            I’m writing that down these sizes on the instruction sheet that came with my mould, and putting a copy in my wallet, going wrench buying.
            This is my first non Lee or Lyman mould….and I must say it is hard  not to drop a good bullet.  I did a couple heat and cool cycles after doing that,  heated up a pot full of alloy  , placed mould across top (no hot plate) to warm,  made two pours and after that every one that dropped out was a keeper.  Cast about 250 ,  and all but 4-6 were keepers ,  the rejects were my fault ,  pretty awesome mould you make,  I will have to say…they are worth the money, every cent.
            I’m also glad I didn’t get a brass mould…..the aluminum 4 cavity is a LOT heavier than I expected.  Having this much mass means they don’t cool down much at all.
            Casting since 1967 and your moulds are the easiest to work.  Heck I didn’t even have to smoke them,  they drop right out from the get-go.  Thanks ,
            Gary

          Viewing 3 replies - 1 through 3 (of 3 total)
          • You must be logged in to reply to this topic.