Flat top punch for HP?

Home › Forums › NOE Forums › NOE Archive › Historical Archive › Using NOE Moulds › Casting and Reloading › Flat top punch for HP?

  • This topic is empty.
  • Creator
    Topic
  • 2017-05-23 at 15:48 #489295
    fredericklindsey
      Up
      0
      Down
      ::

      I acquired a a lightly used 311-155 RG4 and need a Lyman top punch. Is the 308 flat punch what is usually shipped with this mold?

    • Creator
      Topic
    Viewing 3 replies - 1 through 3 (of 3 total)
    • Author
      Replies
    • 2017-05-23 at 18:30 #508129
      AlvinYork
      Participant
        Up
        0
        Down
        ::

        That should work.

        2017-05-23 at 22:57 #508130
        fredericklindsey
          Up
          0
          Down
          ::

          Thank Alvin,
          That’s what I thought. With RG molds and flat point, cup point and hp pins I didn’t think they would send 3 different top punches.

          2017-05-25 at 13:40 #508131
          AlvinYork
          Participant
            Up
            0
            Down
            ::

            You can also, in general, order a flat top punch then in the comments section of the order write in which design you want the punch for and they will cut it for that.

          • Author
            Replies
          Viewing 3 replies - 1 through 3 (of 3 total)
          • You must be logged in to reply to this topic.