- This topic is empty.
-
Topic
-
andyadkins
Guys I think that this would not be too hard to fabricate. Just some simple cailber specific hollowing pionting dies. So that someone with out a hollow piont mould could hollow piont just about anything they would want to?
Basically a centering sleeve & a sized piont bit. Or perhaps a turned dowel bit holder so as to permit the use of a certain size bit there by making bit replacement an easy situation.
I believe that there is alot of guys out there with moulds that we will never see their design in an RG or any other mould for that matter. That is other than sending it to Eric to get it done. Heck this would even work on J-words. Might even work made out of aluminum so as to keep the fab cost down.
I believe that this would sell.
What do you think Al??
andyadkins- You must be logged in to reply to this topic.