HTC-358-170-WFN(powder coat/ HTC design)

Up

0

Down

::

Due to differences in desired designs, I thought it would be best to make a different thread for the two different HTC 357 mag bullets.  Here is the design that BlueJay was more interested in:

Topic

[julianbownesParticipant]

Up

0

Down

::

Perfect sir. Im in for a 5 cavity plain base and an RG4 GC.

[Full.Lead.TacoKeymaster]

Up

0

Down

::

Just gotta get another person or 2 interested and then I can make the group buy official.

[MaxParticipant]

Up

0

Down

::

This looks great except it is a touch heavy for my likes could it be scaled down to around 160 ish?

My most accurate rf molds or swc molds all throw around 158-162 with ww and 1% tin.

[rogerchampParticipant]

Up

0

Down

::

Lol I’d say this is more up my ally. I appreciate smarter people than myself doing drawings and proof of profile like this. I love this idea of the nose better than the 150ish grain better but a touch heavy. Not to say I couldn’t get used to a heavier mold but would prefer to go no heavier than 160 gr if possible. No lighter than 150. My sp101 may like a heavier bullet idk it’s point of aim is slightly low w a 158 so this could take care of that if it were heavier but if I had a similar design I’m used to shooting the 158 class weight. Most likely everyone’s data for 158s are going to transfer w little difference. If we could weigh the bullet less for say a 160 then I’m on board for 2 if not I’m prob on board for two. Is there a chance to lighten it up?

[julianbownesParticipant]

Up

0

Down

::

With a hollow point you’re probably looking at 160. So maybe get one plain base and one hollow point. Gas check design might get it close to your target weight as well.

[rogerchampParticipant]

Up

0

Down

::

Yeah count me in for two for sure. Both 5 cavity plain based non hollow point

[julianbownesParticipant]

Up

0

Down

::

OD,

Thanks. Now we need a couple more to go live.

JB

[Full.Lead.TacoKeymaster]

Up

0

Down

::

Ok guys, I went ahead and made this group buy active.  I still need Al to draw up the official mold pictures with the gas check and hollowpoint options.  Go ahead and sign up at the link below:

http://noebulletmolds.com/smf/index.php/topic,2004.0.html

Once the thread above has 10 people, it will be added to the run schedule.  I am quite excited about this one.

[Author]

Replies