HTC356-135-FN

Up

0

Down

::

Load info and statistics on each image.  We love this mold and love the bullets.  Range scrap was used, so lead content is a little higher and bullets were 1-2 grains over 135.  They Hi-Tek coat great and are easy to load.  A special thanks to AP and Matt in Illinois for testing results.  I can’t wait until the HTC-402-188-WFN  40 caliber version of this mold is ready for my 10mm pistols.

Topic

[roberttotinParticipant]

Up

0

Down

::

More targets.

[roberttotinParticipant]

Up

0

Down

::

More targets

[roberttotinParticipant]

Up

0

Down

::

More target results

[Full.Lead.TacoKeymaster]

Up

0

Down

::

Thanks for posting this!  What gun were you using it in?

[roberttotinParticipant]

Up

0

Down

::

Most guns are noted at top of writing on image.  The two gentlemen that tested the bullets were very skeptical until they actual loaded and shot the bullets.  AP raves about them.  I personally use them in my Glock G19 with a Lone Wolf barrel and love them.  I cast them for AP and Matt and shipped 2-3 K to them in a trade for reloading supplies.

[Author]

Replies