Leaky Mold

  • This topic is empty.
  • Creator
    Topic
  • #488725
    justinsilva
      Up
      0
      Down
      ::

      I have the 502-375-SP mold in brass but the cavities do not seem to seal. every volly has 1 to 3 of the castings with little wings in the spire point section of the bullet. This mold has done this from the very beginning. I had hoped with repeated heating and cooling the mold would settle in, but it has not.
      I am using foundry certified hardball alloy. I have varied the alloy temperature from very hot to just above melting.
      All three cavities have this problem, the hotter the alloy the more it seems to leak. I soaked the mold with liquid wrench and flaked off some smegma that had acumulated in the cavities with a wood stick. Still leaking.
      I’ve never used any abrasive in the mold, i lubricate the sprue plate every couple heatings, i’ve never banged, dropped, or tossed the Mold. I keep the screws screwed down both in the mold and the mold handles.
      I do genuinely take care of my stuff. I’m not well off by any means, so when i buy something I do my best to take care of it.

      I try not to think about this mold, nor look at it given how much cash i laid out for this mold because it makes me pretty angry to have spent so much money on a mold that won’t spit out a proper bullet.
      Today decided tp give it another go after I used my lee mold to bang out some .38 bullets. Still crap.
      I’ve given serious thought to selling the little fucker, but i’m not the sort to knowingly sell a person a lemon.

      What else can i do to make this little bastard stop leaking and produce a real bullet?

    Viewing 3 replies - 1 through 3 (of 3 total)
    • Author
      Replies
    • #504073
      AlvinYork
      Participant
        Up
        0
        Down
        ::

        Is it perhaps the amount of pressure you’re putting on the “squeeze” as you are pouring and waiting for the alloy to cool? I’m thinking it’s not enough.
        The only other thing I could think of is bits of lead in the cooling vents on the mating surfaces of the mould. They might be propping things open and allowing a leak to form the “wings”.

        #504074
        SwedeNelson
        Keymaster
          Up
          0
          Down
          ::

          Jsilva

          Is it the vent lines that you are getting whiskers with or is it a flashing. 
          The best thing to do is to send it back and we will check it out.
          We will fix, replace or get you a refund.
          Not a problem.

          Bullet maker, maker
          Al Nelson

          #504075
          justinsilva
            Up
            0
            Down
            ::

            Hello,
            I neglected to take pictures yesterday, but there was lead following the path of the vent. As the mold got hotter, the leak extended further out to 3-4 tenths of an inch to the sides. They do indeed look like fine silver whiskers.

            When the mold was cooler, I had more of the flashing you mentioned. It started at the tip, progressed down about half way extending about 2 tenths to the side.
            062DB25F-E835-4B6B-971C-ECC8377DC09B_zps0fbghawf.jpg

            Come Monday I’ll pack it up and send her back home with a couple samples so you can see what I’m seeing.

            Thanks,
            Justin

          Viewing 3 replies - 1 through 3 (of 3 total)
          • You must be logged in to reply to this topic.