Lee Sprue Plate Lever on NOE Sprue Plate?

Up

0

Down

::

Has anyone done this? I’m casting my 30 caliber five cavity molds with a linotype mixed alloy and it is a fine line from cutting too early to beating the hell out of the sprue plate to open it. I’m going to tear my molds up.

I was going to drill a hole for the lever pivot but it will just clip the edge. Anyone modify their sprue plate?

Topic

[allenmcclaran]

Up

0

Down

::

I did it to mine, just move it over a little, there is enough slack in the Lee design to move over a little, haven’t had time to try it out yet.

[Anonymous]

Up

0

Down

::

I did it to mine, just move it over a little, there is enough slack in the Lee design to move over a little, haven’t had time to try it out yet.

Thanks!

[Author]

Replies