Long GC shank on the 358009

Home › Forums › NOE Forums › NOE Archive › Historical Archive › General › Forum Questions / Problems › Long GC shank on the 358009

  • This topic is empty.
  • Creator
    Topic
  • #488039
    Irascible
    Participant
      Up
      0
      Down
      ::

      Not a problem or a complaint. It’s a nice mold and cast good bullets easily. I cast with my new 280gr 35 caliber mold today. My that’s a long GC shank! If you ever run another series of these molds, I would think .050″ stolen from the shank and added to the width of the bottom drive band would be an asset.
        Actually, I just looked at the drawing in the store sight. A bit different then I ended up with. My rear band is not that wide and the space above the gas check is not that short!

    • You must be logged in to reply to this topic.