- This topic is empty.
-
Topic
-
Full.Lead.Taco
I picked up one of those fancy NOE pvc/wood “sprue whackers” last week–I think they are called a “mould mallet” in the shop. I had a chance to cast with it for a few long casting sessions, about 12 hours total, and I have decided I really like it! No more wood splinters everywhere (not that it was a huge deal). But the biggest benefit I have seen is that the pvc shell or whatever you want to call it, really gives a good snap to the sprue cutter–much more so than a plain wood stick (or in my case, a cut down 2×4). You don’t even have to whack too hard. Not sure if any of you have tried it, but I would recommend it if you can. I think they only cost around $18 or so. When I used my NOE sprue whacker for the first time, I was reminded of when I used my first NOE mold instead of my Lee molds. Not a “need” if you have a bunch of scrap wood to use as a whacker, but a nice little luxury item that only costs around $18. Anyways, my 2 cents–great product that makes casting even more “luxurious” ha ha.
-
Replies
-
Intel6
I will add my two cents here and also say this is a worthwhile addition. I was using the wood handle from a hammer that the head broke off and then started wrapping it in duct tape. Worked OK for a while and then started getting nasty. Added one of Al’s mallets to one of my orders and I have been extremely happy with it.
If for some reason I was able to wear it out (I don’t think so) I would buy another one without question.
Neal in AZ
Full.Lead.Taco
Full.Lead.Taco
Full.Lead.Taco
Here is a short video for those of you who have never seen one in use before:
Intel6- You must be logged in to reply to this topic.