New member first post

Home › Forums › NOE Forums › NOE Archive › Historical Archive › Using NOE Moulds › Casting and Reloading › New member first post

  • This topic is empty.
  • Creator
    Topic
  • 2017-12-29 at 19:35 #489557
    Quarterbore
    Participant
      Up
      0
      Down
      ::

      Hello, everyone!  I purchased a couple of lightly used NOE .25-100-FN moulds, one g.c., the other plain base.  The only other Aluminum moulds I had used were Lee and NEI..I must admit, I wasn’t too enthused about an AL mould.  But after only 1 casting session with these..and especially during the inspection/weighing process..I must admit I have never cast a more uniform batch of bullets before..including some nice custom moulds..and I have been casting since 1969!  Most bullets are running withen .1 grain.
        I’ll have to wait until Spring to try them out, and I am sure I won’t be disappointed.  Keep up the nice work NOE!

    • Creator
      Topic
    Viewing 2 replies - 1 through 2 (of 2 total)
    • Author
      Replies
    • 2017-12-30 at 07:09 #510035
      adamsutherland
      Moderator
        Up
        0
        Down
        ::

        Welcome to the forum.

        Yes indeed NOE do produce quality moulds, combine that with a rigorous and consistent casting process and quality bullets are the outcome.

        Well done!

        2017-12-30 at 17:41 #510036
        Hugh Kuhns
        Participant
          Up
          0
          Down
          ::

          And please don’t keep this a secret…tell all of your shooting and casting friends!

          762sultan

        • Author
          Replies
        Viewing 2 replies - 1 through 2 (of 2 total)
        • You must be logged in to reply to this topic.