NOE 311-155FN?

Up

0

Down

::

Is anyone using this mold?

http://noebulletmolds.com/NV/product_info.php?cPath=30&products_id=257&osCsid=q4rl5dl8supp48v1jj96s481a4

The site says it’s great for the 30-30, .300blk, and .308win.  I’m assuming that means the meplat is big enough to safely load it in .30-30 for tube fed guns?  At the same time, I have to wonder if the meplat is small enough to feed well in AR’s. 

I’ve been using the Lee 155gr spire point that is intended for the 7.62×39 and sizing it down to .310 for my .30cal guns with good results.  I’ve wanted a nicer mold that’d fill the same role for a while now.  I also have a 30-30 now, and one boolit for all of the above from a top quality mold sure would be sweet.

Is anyone using this boolit?

Topic

[ericstevensParticipant]

Up

0

Down

::

I HAVE that mould and quite a few cast.  It should be a great bullet for most 30cal, but tends to be a bit too blunt at my OAL for feeding in my 300BLK AR.  I’ll have to give them a good test in my 308s and 30-06s.

[ericstevensParticipant]

Up

0

Down

::

I shot that one in my 2 groove ’03 RIA mongrel and was thoroughly impressed.  4/5 shots touching at 50 yards, peep sight, wrist and elbow rest.  I need to try it in my 4 groove 03A3 and Rem700.

[michaelhageyParticipant]

Up

0

Down

::

I have a couple of hundred in different HP configurations sized and ready to load this wkend, would you mind sharing your thoughts on load receipts?  I’ll be loading 30-30’s. 

[bobrobertmaerdian]

Up

0

Down

::

Hello Swede Nelson,

I have wanted to purchase the captured molds for some time.  What are the chances yuou might have some of rhe molds available?

Also, I would like to get a nose punch (RCBS/Lyman style) for each of the molds and Bull Plate.

Thanks for your service!

Bob Maerdian

[quicksylver48]

Up

0

Down

::

A little late to the table but for what it is worth, sub min. @ 100 yds in my 4 groove 03’s w/ 18 grs 2400.
One with Lyman 48, 17 Front.
One with Lyman 10x, both full dress military.

[MaxParticipant]

Up

0

Down

::

Hello
I have shot quite a few of these plain based and get good accuracy.
The issue with the 30-30 is the bullet length from crimp grove forward is to long to feed out of the tube of my win 94.
I have to single load em.
They shoot very accurate but can not be cycled.
If you would like a few plain non hp to try I have some cast and lubed @ .310.
Let me know and I would mail you a handful.

Good luck and shoot straight!!
Slayer

[Author]

Replies