- This topic is empty.
-
Topic
-
milboltnutViewing 4 replies - 1 through 4 (of 4 total)
-
Replies
-
AlvinYork
Sure. Check the very bottom of the below link.
http://noebulletmolds.com/smf/index.php/topic,1245.0.html
Below is the URL to the dies themselves.
http://noebulletmolds.com/NV/index.php?cPath=564_104_410
You’ll also need to buy the sizer you’re interested in.
To start you could just get a nose sizer that’s 2 or 3 thousandths below your maximum, SAAMI, bullet diameter. That should give you the clearance you need to chamber the round. A chamber cast would be optimal as you could get a clear picture as to what’s going on in there and select the best nose sizer for the job.
AlvinYorkViewing 4 replies - 1 through 4 (of 4 total)
- You must be logged in to reply to this topic.