Rg4 220/205 hp .403

Up

0

Down

::

I had started this on cast boolits but was advised to move it here.

Here’s the link:
http://castboolits.gunloads.com/showthread.php?237271-probing-for-interest-in-heavy-10mm-hp-group-buy-from-NOE&p=2863516#post2863516

Hoping to get ten to get a run done, and may even be interested in getting one made of … Brass?
Hope this works!

Topic

[erickelley]

Up

0

Down

::

I’m in if I can get brass

[SwedeNelsonKeymaster]

Up

0

Down

::

Something to look at

Brass is no problem – should start to see more of it from us soon
Bullet maker, maker
Al Nelson

[robertwheary]

Up

0

Down

::

I thought I might bring this one back from the dead.
There are more users to gawk at this pretty design and a couple of heavy 10mm threads about.

[robertkarkutParticipant]

Up

0

Down

::

I really like that 205 gr. hp. If this goes active you can count me in.
I would like to see a gas check option since this would be pushed hard in a 10mm gun.

[Pinsnscrews]

Up

0

Down

::

This is what I am really looking for! I do also like the “Dish” style pins for the nose as an option to a full hollowpoint.

That said, I would be in for a 2 Cavity mold with HP, FN, and a Dish style pins in Aluminum. (Limited funds)

[robertwheary]

Up

0

Down

::

Well that’s four. Any more?

[georgeafenleyiiiParticipant]

Up

0

Down

::

Hi, I would be interested in getting a mold 10mm mould.
                              4 cavity in brass, 2nd choice alum

[georgeafenleyiiiParticipant]

Up

0

Down

::

Again hi, was so eager I replied before I finished.
                                            would like it in 2pb/2gc. if not then all gc’d
and what would it weight as a hollow point?  Thanks George

[Author]

Replies