What mold would be best for a 22TCM

Home › Forums › NOE Forums › NOE Archive › Historical Archive › General › Forum Questions / Problems › What mold would be best for a 22TCM

  • This topic is empty.
  • Creator
    Topic
  • #488287
    terrycunningham1
      Up
      0
      Down
      ::

          I have recently picked up a Armscor 22TCM/9mm combo and I am not sure what length the 40 grain factory bullet is I know the OAL of the loaded cartridge is the same as a 45 acp . I do not want to have to shoot just jacketed bullets when I get set up for reloading and I know a GC would be required due to the velocity of the round. There is not a lot of loading info published yet about this round especially with cast bullets. If I need to I can pull the bullet from a loaded round so that I would know what mold to try but if anyone has that info I would be grateful.

    Viewing 3 replies - 1 through 3 (of 3 total)
    • Author
      Replies
    • #500465
      Intel6
      Participant
        Up
        0
        Down
        ::

        Just a guess knowing the intended cartridge…

        225-37-FN  with a GC. I have this mould for my .22 Hornets and it is close to the style of the factory bullet and due to LOA/magazine restrictions and length of the neck it seems to be the only one that would possibly work.

        Neal in AZ

        #500466
        terrycunningham1
          Up
          0
          Down
          ::

              That’s what I was thinking as well since a longer bullet would be too far in and out of the case. Thanks

          #500467
          bobdavis
          Participant
            Up
            0
            Down
            ::

            Maybe look at the 225-48- in the group buy section

          Viewing 3 replies - 1 through 3 (of 3 total)
          • You must be logged in to reply to this topic.